Kicker CXA360.4 4-Channel Amplifier 90Wx4 Bridgeable

Kicker CXA360.4 4-Channel Amplifier 90Wx4 Bridgeable

R4,349.00

The Kicker CXA360.4 four-channel amplifier delivers up to 90 watts per channel at 2 ohms, powering all door speakers with variable KickEQ bass boost and integrated FIT+ noise rejection.

Out of stock

SKU CX360.4 Category Brand:

Vehicle logos indicate compatibility only. This product is not manufactured or endorsed by the vehicle brand.

Frequently Purchased Together

No results found.

The Kicker CXA360.4 is a compact four-channel car amplifier designed to power full-range door speakers or bridged front/rear pairs. It supplies up to 90 watts x4 at 2 ohms, 65 watts x4 at 4 ohms, and 180 watts x2 bridged, and accepts speaker-level inputs up to 40 volts so line-out converters are often unnecessary.

Built on a Class A/B topology, the amp includes a variable 12dB/octave crossover (50-200 Hz), a variable KickEQ bass boost 0-6dB at 40 Hz, three-second turn-on/off delay, and FIT+ fail-safe integration for strong noise rejection with factory radios. Vertical mounting hardware is included and the unit supports the CXARC remote bass control when configured correctly.

  • Model: CXA360.4
  • Power: 65W x4 at 4 ohm stereo
  • Power: 90W x4 at 2 ohm stereo
  • Power: 180W x2 bridged at 4 ohm mono
  • Topology: Class A/B four full-range channels
  • KickEQ: Variable 0-6dB boost at 40 Hz
  • Active Crossover: Variable 12dB/octave 50-200 Hz; HI, LO or OFF
  • Input Sensitivity: Low level 125 mV to 5 V; High level 1 V to 40 V
  • Signal-to-Noise Ratio: 95 dB
  • Frequency Response: 10 Hz to 20 kHz
  • Turn-on/off Delay: 3 seconds
  • CXARC Remote Bass Capable: Yes (remote sold separately; AMP2 must be in LO-PASS X-OVER mode)
  • Dimensions: H 2-3/8 in (5.9 cm) x W 6-3/4 in (17 cm) x L 12-1/2 in (31.7 cm)
  • Subsonic Filter: n/a
  • Class A/B four-channel design
  • 90W x4 at 2 ohm, 65W x4 at 4 ohm, 180W x2 bridged
  • Variable KickEQ bass boost 0-6dB at 40 Hz
  • Variable 12dB/octave crossover 50-200 Hz
  • Accepts up to 40V high-level speaker inputs
  • FIT+ fail-safe integration for noise rejection
  • Three-second turn-on/off delay to reduce interference
  • Compact footprint with vertical mounting hardware included
  • Compatible with CXARC remote bass control (sold separately)
  • Disconnect the vehicle battery negative before installation
  • Install an appropriate inline fuse near the battery on the power lead
  • Verify correct polarity on power and speaker connections to avoid damage
  • Provide adequate ventilation around the heat sinks and avoid covering the unit
  • If unsure about wiring or mounting, consult a professional installer
  • Designed for 12V automotive electrical systems
  • Works with most aftermarket head units
  • FIT+ provides noise rejection for many factory amplified systems
  • Accepts up to 40V speaker-level inputs so it can interface with factory speaker outputs

you may like

Related Products

RCS Logo